Falcon Professional+100 FX Dual Fuel User's Manual & Installation Instructions

Falcon Professional+100 FX Dual Fuel User's Manual & Installation Instructions Manual pdf 40 page image

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSONDisconnect from electricity before servicing. Check appliance is safe when you have finished.36Top stripRubber stripArtNo.320-0005 Oven door rubber seal5 Doors5.1 To Replace an Oven DoorOpen the oven door fully and place the suppliedholding pins in the drop down hinges (Fig. 9.10).Lift the door panel up and out.Carefully fit the new door panel and push down gentlyto release the holding pins.nn THE DOORS ARE HEAVY, SO TAKE CARE.5.2 Oven Door GlassThe inner glass on both oven doors is replaceable.Open the oven door fully and place the suppliedholding pins in the drop down hinges (Fig. 9.10).Lift the door panel up and out.Remove the top 2 fixing screws using the Allen keysupplied and the door top strip (Fig. 9.11). Then lift the2 glass panels out.To refit the door glass correctly, make sure that theprinted circle and square on the glass, match up to thepressed holes of the same shape. This will ensure theheat reflective side is in the correct position, facingtowards the oven.Make sure that the rubber strips are all attached.Carefully refit the door panel and push down gently torelease the holding pins.nn ENSURE THAT ALL PIECES OF BROKEN GLASS AREREMOVED5.3 To Replace an Oven Door Outer PanelOpen the oven door fully and place the suppliedholding pins in the drop down hinges (Fig. 9.10).Lift the door panel up and out.Remove the top 2 fixing screws using the Allen keysupplied and the door top strip (Fig. 9.11). Then lift the2 glass panels out.Remove the two nuts located on the inside of the doorpanel, to release the handle (Fig. 9.12).Remove the two fixing screws located at the base of theoven door and remove the outer door panel (Fig. 9.12).Reassemble in reverse order.5.4 To Change an Oven Door SealOpen the oven door. The seal is held in place by smallhooks on the rear face. At the corner, pull the sealdiagonally away from the door centre until that hookis released (Fig. 9.13). Proceed to the next hook andrelease it in a similar way, and so on. Use force if thehooks are stiff, as the old seal will be discarded.When fitting the new seal, position the seal join at thebottom. Hook the new seal in one of the corner holes ofthe door, and proceed round the door, snapping in eachhook in turn.Fig. 9.10Fig. 9.11Fig. 9.12Fig. 9.13Handlefixings x 2Outerdoor panelscrews x 2