Fantech RE41999R Installation & Maintenance Instructions Manual

Also see for RE 10XL: Installation instructions

Contents

TYPICAL INSTALLATIONSINSTALLATION & MAINTENANCEINSTRUCTIONSSERIESRERead and Save These Instructions !DO NOT CONNECT POWER SUPPLY until fan is completely installed. Makesure electrical service to the fan is locked in “OFF” position.1. All units are suitable for use with solid-state speed control.2. WARNING! TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, ORINJURY TO PERSONS--OBSERVE THE FOLLOWING:a. Use this unit only in the manner intended by the manufacturer. If youhave any questions, contact your manufacturers representative.b. CAUTION: Before installation, servicing or cleaning unit, switch poweroff at service panel and lock the service disconnecting means to preventpower from being switched on accidentally. When the servicedisconnecting means cannot be locked, securely fasten a prominentwarningdevice, such as a tag, to the service panel.c. Installation work and electrical wiring must be done by qualifiedperson(s) in accordance with all applicable codes and standards,including fire-rated construction.d. Sufficient air is needed for proper combustion and exhausting of gasesthrough the flue (chimney) of fuel burning equipment to prevent backdrafting. Follow the heating equipment manufacturer’s guideline andsafety standards such as those published by the National Fire Association(NFPA), and the American Society for Heating Refrigeration and AirConditioning Engineers (ASHRAE), and the local code authorities.e. When cutting or drilling into wall and ceiling, do not damage electricalwiring and other hidden utilities.f. Ducted fans must always be vented to the outdoors.g. If this unit is to be installed over a tub or shower, it must be marked asappropriate for the application and be connected to a GFCI (GroundFault Circuit Interrupter) - protected branch circuit.h. NEVER place a switch where it can be reached from a tub or shower.3. WARNING! Check voltage at the fan to see if it corresponds to the motorname plate.INSTALLATION1. The compactness and adaptability ofModels RE fans permit easyinstallation. The fans are shipped fullyassembled and can be mounted atany angle. For various mountingsee figures below.2. Because this unit has rotating parts,safety precautions should beexercised during phase of installation,operation and maintenance.3. CAUTION: “For General VentilationUse Only. Do Not Use To ExhaustHazardous Or Explosive Material andVapors.”4. Remove unit from package andinspect within 15 days after receipt.If damaged, report damage to carrier.Do Not operate this unit with visibledamage to the blower or impellerassembly.5. CAUTION: “This unit has anunguarded impeller. Do not use inlocations readily accessible to people oranimals.”WEAR HAND PROTECTIONAND STAY CLEAR OF SHARPEDGES.6. Screen guards must be installed whenfan will be within reach of personnel,within (7) feet of the working area, orwhen advisable for safety.7. Install intake side of fan facing anunoccupied space.Wall mountPitched roof with flat baseFlat roof for curb mountRange hood venting Dryer venting Bathroom venting1712 Northgate Blvd-Sarasota, FL. 34234Phone: (800) 747-1762 Fax: (800) 487-9915Phone: (941) 351-2947 Fax: (941) 359-3828Web Site: www.fantech-us.comRE41999R

/ 4

Related manuals for Fantech RE 10XL