Fantini Cosmi CH150 Manual

Also see for CH150: Manual

Contents

18Fixing the chronothermostat to the baseFix the chronothermostat to the base by manual pressure, making sure that the multi-poleconnector is inserted correctly. The chronothermostat connection is snap-in.Configuring the chronothermostatNote: Configuration must be performed only by qualified personnel.By configuring the chronothermostat one can personalise its operating parameters. Toaccess the configuration programme, proceed as follows.1. Press the SET / PROG key [key 6]. The current mode of operation is temporarilyinterrupted and is resumed automatically when programming ends.2. Press and hold down the SUMMER / WINTER key [key 10] for about 5 seconds.The configurationparameters, each of whichhas its own preset value,are identified on the displayby a number and writing. Tochange the values of aparameter use the keys ▲[key 1] and ▼ [key 2]; tomove between theparameters, use the key ►[key 4].To return to the initial page of the programming menu, press the ENTER key [key 5], whichsaves the changes in the memory.If no key is pressed for 3 minutes, the chronothermostat exits the configuration programmeand returns to the mode of operation previously in use, without saving.To eliminate the changes made and restore the preset values of the configurationparameters, press keys ▲ [key 1] and ▼ [key 2] simultaneously and hold them down forabout 4 seconds.SCRITTA VALOREINDICE