Far south networks Com.X1 Getting Started
Also see for Com.X1 PBX: User guideAdministrator's guide
    | |
Com.X1Getting Startedhttp://www.farsouthnet.comVersion 1.01, July 26, 2010Welcome to the world of Comma intelligent Asterisk™ solutions! This leaflet will help you to getstarted with your new Com.X1 solution. This getting started guide addresses networking andinstallation of the Com.X1 unit and should be read in conjunction with the Com.X1Administrator's guide.For further information see http://farsouthnet.com/mediawikiDescriptionThe figure above shows a typical Com.X1. The BRI and FXS/FXO positions are modular andmay or may not be present, depending on model.The available slots for analogue interfaces are numbered a1 & a2. Each a1 & a2 slot may beinstalled with octal FXO, octal FXS or 4FXS/4FXO card, providing eight RJ11 ports, numbered1 to 8. Thus each analogue RJ11 interface is designated a1-1 to a1-8 and a2-1 to 8.A single slot is available for Basic Rate ISDN (BRI) interfaces, it is numbered d1. The d1 slotmay be installed with a quad BRI card, providing four RJ45 ports, numbered 1 to 4. Thuseach BRI interface is designated d1-1 to d1-4.A single Primary Rate ISDN (E1 PRI) interface is provided.Three 100Base-T LAN interfaces are provided, designated LAN1 (Eth0), LAN2 (Eth1) & LAN3(Eth2).The remaining connectors are Earth, Power, USB0 & USB1, as shown.The front panel LED (not shown) displays basic diagnostic information as follows:Code DescriptionFlashing red No networkSolid yellow Boot stateFlashing green/red Manager or stream error (check softwareconfiguration)Solid green 0KCopyright © 2008-2010 Far South Networks (Pty) Ltd |
Related manuals for Far south networks Com.X1 PBX
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine