Fat Shark 5DVR Operation1. SD card MUST be formatted before use to ensure stable recording.2. DVR is for analog recording only, no HD recording.3. Do not place alternative files that you want to keep into the DVR. The DVR may notrecognize the file space and write over your files. Use dedicated SD card.Recording:After powering goggles, turn on DVR by depressing vertically and holding the DVR controlbutton for 1 full second (long press).RED LED should now show solid.Ensure SD card is inserted and short press to start recording (RED LED will slowly FLASH (~2times/second). Single beep on record start.Short press again stops recording (turns to solid RED LED). Double beep on record stop.PlaybackPlaying back the recording files must disconnect the external receiver and remove the AV insource (preventing OSD menu conflict)After turning on DVR and in stop record mode (SOLD RED LED) depress and hold DVR buttonfor 1 second (long press) to enter menu.Menu NavigationPlayback (press right to enter)Now can see: Preview shot with file numberpress up/down to change file numberpress right to playUp/down controls playback speed/directionRight press pause/playLeft press, back to main menuFormat (press right to enter)Execute (press right)Record (press right)Now can see:default (no recording until press the button to start)auto start (auto start recording when power on)auto start continuous (auto start recording when power on and overwrite the file ifspace is full)press up/down to select the recording modepress right to enter to confirmPressing left from main menu exits menuAV Cable Pinout3.5mm AV Connector: Yellow: Video,White: Audio Left, Red: Audio RightExternal video recordingUse the AV cable to insert the AV in/out connector on the right side of goggle, and connect theexternal video recording device to the other end of AV cable(Please refer to the equipmentsupplier's instructions for the relevant settings).Gr ound Vi deo AudR AuL