Fedders A7Q08F2B Manual

Also see for A6Q10F2B: Manual

Contents

Fedders A7Q08F2B Manual Manual pdf 5 page image

5Power ControlThe Power Control turns the unit on and off.Set Temperature/Timer DisplayShows the set temperature when the unit is in operation and hours when the timer isbeing set. THE TEMPERATURE DISPLAY ONLY SHOWS THE SET TEMPERATURE, NOTTHE ACTUAL ROOM TEMPERATURE.Temperature/Timer Hour ControlsThese buttons are used to raise or lower the set temperature in increments of 1° from66°F to 88°F. By depressing both buttons at once, the display will toggle betweenCelsius and Fahrenheit. When the timer is being set, these buttons are used to changethe hour setting in increments of 1 from 00 to 24.Check Filter Light/Reset (some models)After 250 hours of usage the Check Filter lightwill turn on. At this time, the filter needs to be removed and cleaned (see page 8). Afterthe filter is cleaned and repositioned, depress the Resetbutton. This will restart the counter and turn the light off.Mode ControlA green light will indicate which mode is currentlybeing utilized.Cool Mode – The unit will circulate and cool the air.Heat Mode (Heat Models Only)– The unit will circulate and heat the air.Heater Safety Feature- When heater is powered off, low fan will automatically stay onand run for 60 seconds to ensure the removal of residual heat, meanwhile, the Low FanLED blinks until the low fan stops.Fan Mode – The unit will only circulate the air.Energy Saver Mode –(The energy saver mode is designed to operate with Cool mode only)The fan will switch from the set fan speed to LO whenever the compressor turns off inresponse to the thermostat. When the compressor cycles back on, the unit will return tothe original fan setting.Fan Speed ControlHigh, Medium*, Low and AutoThe settings are adjusted with the Fan Speed Control, each time the button is depressedit changes the setting. A green light will indicate which setting is currently being used.When the AUTO feature is selected while the air conditioner is in the COOL or HEATmode, the fan speeds will change automatically as the temperature in the roomchanges.COOL Mode• 7° or more above the set temperaturewill use HI FAN.• 4° or less above the set temperaturewill use LO FAN.HEAT Mode (Heat models only)• 9° or more below the set temperaturewill use HI FAN.• 4° or less below the set temperaturewill use LO FAN.*MEDIUM FAN NOT available on HEAT models.Set Temperature/TimerDisplayTemperature/TimerHour ControlsTimer ControlFan Speed ControlModeControlPowerControlAA.D.B.E.C.F.BCDEFBuilt-in three minute timing delay.If this electronic unit will not respond to touch pad orremote control commands, it is necessary to unplug theunit from the electrical outlet for five seconds and thenplug the unit back in.Auto restart feature:In the event of a power failure, this feature allowsthe unit to resume operation once power hasbeen restored, retaining the most recent settings.Upon restoration of power, the timer mode mayneed to be reset if being utilized.OPERATIONCAUTIONHeat/Cool models or units with electricheat are designed to be used only as asupplemental heat source. They should beused in addition to regular heatingsystems and never as the primary sourceof heat.