Federal SNR482C-2 Installation And Operation Instructions Manual

Federal SNR482C-2 Installation And Operation Instructions Manual Manual pdf 5 page image

Series ’90 Refrigerated Bakery Page 5CAUTION: Do not push against the curved glass, end glass, doors or door frameswhen removing the case from the skid or moving the case. Case damageor glass breakage could result.PRE-INSTALLATION PROCEDURESInspection for Shipping DamageYou are responsible for filing all freight claims with the delivering truck line. Inspect allcartons and crates for damage as soon as they arrive. If damage is noted to shipping cratesor cartons or if a shortage is found, note this on the bill of lading (all copies) prior tosigning.If damage is discovered when the case is uncrated, immediately call the delivering truck lineand follow up the call with a written report indicating concealed damage to your shipment.Ask for immediate inspection of your concealed damage item. Crating material must beretained to show the inspector from the truck line.INSTALLATION INSTRUCTIONSLocating the Display CaseThe case should be located where it is not subjected to the direct rays of the sun, heatingducts, grills, radiator, or ceiling fans, nor should it be located near open doors or main doorentrances. Also, avoid locations where there is excessive air movement or air disturbances.The condenser inlet is located at the rear of the case. Do not block this inlet and do notlocate the air inlet near a source of heat.Removing the case from Shipping SkidMove the case as near as possible to the final location before removing it from the shippingskid.Remove the four (4) bolts that secure the case to the skid. Do not remove the shippingbrackets from the case. The brackets are intended to be used as hand grips for locating thecase.Remove the brackets when the case is in the final location