Feig Electronic OBID Classic-Pro Series Montage And Installation

Also see for ID CPR50.10-E: Installation manual

Contents

Feig Electronic OBID Classic-Pro Series Montage And Installation Manual pdf 19 page image

OBID® classic-pro Montage ID CPR50.10-E/-REFEIG ELECTRONIC GmbH Seite 19 von 39 M90701-1de-ID-B-FCC.docD E U T S C H5.1. ZulassungFunk- Europa- USAEN 300 330FCC 47 CFR Part 15EMV EN 300 489Sicherheit- Niederspannung- Human ExposureEN 60950EN 50364Umwelt RoHS - 2002/95/ECWEEE - 2002/96/EC5.2. Europa (CE)Die Funkanlage entspricht, bei bestimmungsgemäßer Verwendung den grundlegenden Anforde-rungen des Artikels 3 und den übrigen einschlägigen Bestimmungen der R&TTE Richtlinie1999/5/EG vom März 99.Equipment Classification gemäß ETSI EN 300 330: Class 25.3. Declaration of Conformity for USAThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference re-ceived, including interference that may cause undesired operation.Usually this is followed by the following FCC caution:Any changes or modifications not expressly approved by the party responsible for compliance could void theuser's authority to operate this equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pur-suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiate radio fre-quency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-ence to radio communications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try to correct the interference byone or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.