Feig Electronic OBID i-scan ID ISC.MR200-EP Installation Manual

Feig Electronic OBID i-scan ID ISC.MR200-EP Installation Manual Manual pdf 48 page image

OBID i-scan® Montage / Installation ID ISC.MR200-W/EPFEIG ELECTRONIC GmbH Page 48 of 53 M50808-4de-ID-B.docE N G L I S H5 Startup5.1 Port configurationBoth Reader ports (RS232 and LAN/WLAN) can be used for communication. The Readerautomatically detects which port is being used for communication. The RS232 port is used as aservice port and thus has higher priority. If communication takes place on the RS232 port, theother port is disabled for a time of 10 seconds. This lockout can be cancelled by means of a reset.Baud rate 38400Frame 8E1Table 5-1: Standard configuration of the RS232 port5.1.1 Ethernet Interface(ID ISC.MR200-EP)The prerequisite for using TCP/IP protocol is that each device on the network have a unique IPaddress. All Readers have been assigned a factory default IP address.Network AddressIP address 192.168.10.10Subnet mask 255.255.255.0Port 10001Table 5-2: Standard configuration of the Ethernet interfaceNote:The Readers must be connected to the network and configured in succession.