Fein MBS 16 Instruction Manual

Also see for MBS 16: Manual

Contents

Fein MBS 16 Instruction Manual Manual pdf 10 page image

10MBS 16ENSafety instructions.Danger of accidentsThe drive machine must not be able todescend on its own accord while the toolis inserted; if necessary, the hexagonnut (250) must be adjusted.Before adjusting, pull the plug fromthe socket and remove thecap (480).Caution! Sensitive electronics under-neath the cap.See exploded drawing.Risk of injuryFor drilling in walls and ceilings, the toolmust be secured using the safety strapsupplied with it. The magnetic adhe-sion is not activated during a cur-rent interruption.The tool may only be operated if theshock-proof sockets fulfil the regulations;detaching the earthing contact connec-tions is not permissible.Only use undamaged connecting cablesand, if necessary, shock-proof extensioncable and at regular intervals check thatthey are not damaged.Never allow your fin-gers to enter therotating parts.Do not rivet or screw any labels or signson the power tool. We recommend adhe-sive labels.The performance of the power tool to beused must be such that the magnetic adhe-sion force is not exceeded while working!Danger of accidents!Risk of injuryThe mains voltage must correspond withthe voltage specifications on the powertool.Personal protective equipment.When using this device wear the protec-tive items stipulated for work using thedrive machine (see the operating instruc-tions for the drive machine).Handling. The chipping protector (10) mustalways be mounted to protect the userfrom the chippings.The contact surface for the magnetic footmust be smooth, clean and rust-free.Remove any varnish or flat coat.The drill stand is not suitable for anti-mag-netic materials.For guaranteeing the magnetic adhesionforce also for steel materials of less than12 mm thickness, the work piece shouldbe reinforced using an additional steelplate.Danger of injury! Danger of anelectric shockWhen working on walls and ceilings,avoid any (coolant) fluid penetrating themagnetic drill stand. We recommendworking without any coolant.Clamp the drive motor in the drive motorholder at right angles. If necessary, usereducing rings (accessories).Connect the drive motor to the built-insocket (6).For switching ON/OFF. First check that the connection cableand plug are not defective.Proceed in the given sequence! Check that the magnetic switch (7) andthe switch on the drive machine areswitched off.!!!!3 41 01 024 06 7.book Seite 10 Mittwoch, 5. Mai 2004 9:50 09