GARDINER TECHNOLOGY GARDTEC 500 Series Installation Instructions Manual
Also see for Gardtec 500 series: User manual
                                        | |
Contents
| 
GARDTEC580 ENGINEERS MANUALPage 2Planning the Control Panel LocationConsideration in locating the fixing position of the Control Panel should be given to:The underside position of the lid securing screw with relation to the coverfitting and removal.Access for the routing of cables for the system from detection devices,sounders (internal and external), remote keypads, mains, etc.The fixing of a 3 amp unswitched fused spur.Operation of the onboard keypad.Readability of the display.InstallationSlacken the cover screw located on the lower edge of the Control Panel but do notremove completely.Pull the lower edge of the cover forward and upwards in one movement. Store cover ina safe place.Although the main P.C.B (Printed Circuit Board) is protected by the plastic mouldingwe would recommend that it is removed until the rear portion of the Control Panel isfixed to the wall.To do this remove the speaker wires from the terminal block. Unclip the P.C.B fromone of the side clips and lift clear of the other side clip with a sidewards motion. Unplugthe a.c/battery connection from the underside of the P.C.B. Store the P.C.B in a safeplace.Mark the fixing position on the wall (one upper hanger and two fixing holes) using theControl Panel backplate as a template. Under no circumstances should you drill whilstholding the backplate in position.Fix to the wall using appropriate wall plugs and No.8 screws at least 30mm long. Donot tighten the screws at this stage, wait until all your wiring is in place.Technical Manuals Online! - http://www.tech-man.com |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine