GAUPNER HoTT Hornet 250 Manual
                            | |
Contents
| 
20 / 28 16540_jh_V1Necessary pre-settings on the transmitterIn the transmitter it must be selected a free model memory, themodel type must be “surface model“ and the channel 1 directionmust be set so that in “motor off“ position the power indicatormust show -100%.The flight mode must be set on channel 5. Then program a 2way switch for channel 5 to control the flight mode:Attitude mode: Channel 5 = -100% to +50%. The stick move-ment influences the HoTT Hornet reaction on Roll and Nick. Itallows a maximal angle of about 50° at 100% of stick move-ment. Mode suggested for beginners. The stick movementsacts directly proportionally to Roll and Nick.Rate mode: Channel 5 = more than +50%. The stick movementinfluences the rate without angle limit. Aerobatic mode thatallows rolls and loopings.We suggest to set the fail-safe on channel 5 and channel 1 at-100% , so that in fail safe it is active the attitude mode.Program always the motors stop switch on the transmitter. (Seetransmitter manual) This prevents accidental starting of motors,thus reducing the risk of injury.Initialization of the gyro in the receiverOnce the HoTT Hornet has been switched on, the gyro immedi-ately becomes active but still needs to be initialized. To initializethe gyro, keep your HoTT Hornet still when you switch it on. Thecalibration process can only be performed when the receiver isabsolutely still. After 3 seconds in still position you will hearbeeps emitted by all motors.These "wiggles" signal that initialization has been successful andthat calibration is complete. Always wait until the calibration pro-cess has finished before starting to fly the model.The motors will not start until the calibration is successfullycompleted.Auto-flip function version 16540.CAMThe auto-flip function allows you to flip your copter in a very easyway. It is essential that you control in Attitude mode (function notallowed in Rate mode). The auto-flip function is controlled by aswitch assigned to channel 6. (see manual S1019) Activate theswitch and within 5 sec move the nick or roll stick to more than50% of its course, then the copter makes autonomously a flip inthe selected direction. After the flip it is possible to have somelittle position movements (<10°)Do not forget to set the failsafe up!Program the motor stop switch!Safety function - motors-off |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine