76 232001840G(08)5.2 The LaserPro C180II Print DriverWith the LaserPro C180II print driver successfully installed, you will need to adjust the printer and pagesize default settings before you can begin editing and completing jobs. By doing so, you will be setting thework area in your graphics software to match the LaserPro C180II’s worktable area.NOTEPlease make sure the LaserPro C180II is set to the default printer before proceeding to thepage and layout setup.Ensure that the LaserPro C180II has been selected as the DEFAULT PRINTER. You can do so by going intoyour Windows Control Panel → Printers and Faxes.If LaserPro C180II is not selected as DEFAULT PRINTER, you may set it up through the graphics software aswell. The following is taking Corel Draw as example of how to set up LaserPro C180II as the Printer.1) From the primary menu, click FILE → PRINT SETUP.2) From the navigation bar Name, click C180II → OK5.2.1 Page Setup and OrientationThe first thing you must do before working with the LaserPro C180II Print Driver will be to make surethe page and layout settings are properly configured within your graphics software. You will need toaccess and edit the Page Setup or Layout page of your graphics software to set your graphicssoftware’s page layout to match the LaserPro C180II’s work table’s dimensions and orientation.From your graphic software’s Page Setup page:• Set the page orientation in the graphics software to Landscape mode.• Set page size horizontal length to 458 mm (18 inches) and vertical height to 305 mm (12 inches).