GE 16 Owner's Manual And Installation Instructions

Also see for TOP-FREEZER 16: Owner's manual Owner's manual Use and installation guide Use and care guide with installation instructions Owner's manual

GE 16 Owner's Manual And Installation Instructions Manual pdf 15 page image

BEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT – Save theseinstructions for local inspector’s use.• IMPORTANT – Observe allgoverning codes and ordinances.• Note to Installer – Be sure to leave theseinstructions with the Consumer.• Note to Consumer – Keep these instructionsfor future reference.• Skill level – Installation of this appliance requiresbasic mechanical skills.• Completion time – Refrigerator Installation15 minutesReversing the Door Swing1 hour• Proper installation is the responsibility of theinstaller.• Product failure due to improper installation is notcovered under the Warranty.• Do not install the refrigerator where the temperaturewill go below 60°F (16°C) because it will not run oftenenough to maintain proper temperatures.• Install it on a floor strong enough to support it fullyloaded.REFRIGERATOR LOCATIONAllow the following clearances for ease of installation,proper air circulation and plumbing and electricalconnections.• Sides 3/4″ (19 mm)• Top 1″ (25 mm)• Back 1″ (25 mm)CLEARANCESLeveling legs near each front corner of the refrigeratorare adjustable. They firmly position the refrigeratorand prevent it from moving when the doors areopened. Leveling legs should be set so the front of therefrigerator is raised just enough that the doors closeeasily when opened about halfway.Turn the leveling legsclockwise to raise therefrigerator,counterclockwise to lower it.Rollers next to the leveling legs allow you to move therefrigerator away from the wall for cleaning.Turn the legs counterclockwise until the weight of therefrigerator is transferred from them to the rollers.After rolling the refrigerator back into place, turn thelegs clockwise until the legs again bear the weight ofthe refrigerator.ROLLERS AND LEVELING LEGSIf the refrigerator has an icemaker, it will have to beconnected to a cold water line. A water supply kit(containing copper tubing, shutoff valve, fittings andinstructions) is available at extra cost from your dealer,by visiting our Website at ge.com (in Canada atwww.geappliances.ca) or from Parts and Accessories,1.800.661.1616.WATER SUPPLY TO THE ICEMAKER(on some models)7Installation InstructionsModels 16, 17, 18If you have questions, call 1.800.GE.CARES or visit our Website at:ge.comIn Canada, call 1.800.561.3344 or Visit our Website at:www.geappliances.ca