GE 164D4290P393 Owner's Manual And Installation Instructions

Contents

12REMOVE DUCT KNOCKOUTIf recirculating, non-vented ductless (JN327 and RN328,and optional for JV347 and JV367 models only), skip toStep 10 D and proceed.Using a flat blade screwdriver, remove the appropriateduct knockout from the top or back of the hood.31⁄4″ x 10″ Rectangularvertical discharge.Remove top rectangularduct knockout only.7″ Round verticaldischarge. Remove circularduct knockout only.31⁄4″ x 10″ Rectangularhorizontal discharge. Removerear rectangular duct knockout only.FOR 3 1⁄4″ X 10″ RECTANGULARDUCTED DISCHARGEINSTALLATIONS ONLY:Attach exhaust adaptor/damper over the appropriateknockout opening (for vertical or horizontal,depending on installation) with two exhaust adaptorscrews. Make sure damper pivot is nearest to top/backedge of hood. Remove tape from damper flap.Up to 1″ side-to-side adjustmentTapeTop/back edgeExhaust adaptor/damper(vertical discharge position)Pivot(depending oninstallation)FOR 7″ ROUND VERTICALDUCTED DISCHARGEINSTALLATIONS ONLY:Bend up the duct alignment ears in preparation forlater attachment of the 7″ duct.7 89Installation InstructionsNOTE: The exhaust adaptor/damper can be installedup to 1 inch on either side of the hood center toaccommodate off-center ductwork. In extreme off-center installations, one end of the duct connector mayneed to be trimmed to clear the electrical cable clamp.Exhaust adaptor/damper(horizontal discharge position)Attachment ear tabs