CARE AND CLEANING —Half-width Drawerswith Plastic CoverTo remove the drawers, lift front upslightly and pull the drawer straightout.To remove the cover, support it withone hand, tilt it and take it out.If the cover support at front center(on models so equipped) becomesseparated from the drawer cover,(continued)reinstall the support before returningthe cover to the cabinet.To reinstall the cover support,turn the cover and support upsidedown and guide the pins on thesupport into the hooks on the coveras shown. Then push firmly untilthe pins lock into place.The drawer coversupport assemblyconsists of a post, asleeve and a foot.The sleeve and posthave adjustmentteeth which, whenengaged, lock themtogether; and whendisengaged, allowthe sleeve to moveup and down freelyin the post.r Sleeve=4=’00’The support assembly is adjustedat the factory. To readjust it, ifnecessary:1. Make sure the support assemblyis firmly attached to the drawercover and the drawer cover is inplace in the cabinet.2. Make sure the adjustment teethare disengaged. (If engaged, turnthe sleeve 1/4 turn counterclockwiseto disengage them.) With the foot ofthe support assembly resting on thecabinet floor and the sides of thecover resting on the ledges on thecabinet’s side walls, turn the sleeve1/4 turn clockwise tore-engage theteeth. Note: If teeth do not mesh,move the sleeve up slightly as youturn it. Do not raise the drawer cover.To reinstall thefoot if it comesoff, guide the pins —on the foot into the MOfthesleeve” &’slots at the bottomEl Then turn thefoot clockwiseS until the pins. -- snap firmlyinto place.Light Bulb ReplacementA light bulb and socket are located at the top of thefresh food compartment opposite the temperaturecontrol panel.Some models also havea bulb and socket in theupper left comer of thefreezer compartmentbehind a flexible. light shield.To replace either bulb, unplug refrigerator from itselectrical outlet, unscrew bulb when cool, and replacewith similar size bulb. —12