GE 197D4618P002 Owner's Manual And Installation Instructions

Also see for 20: Owner's manual Use and care guide Use and care Owner's manual and installation instructions Owner's manual and installation instructions

Installation RefrigeratorInstructions Models 20 and 22Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.comIn Canada, call 1.800.361.3400 or Visit our Website at: geappliances.caBEFORE YOU BEGINRead these instructions completelyand carefully.• IMPORTANT — Save theseinstructions for local inspector’s use.• IMPORTANT — Observe allgoverning codes and ordinances.• Note to Installer – Be sure to leave theseinstructions with the Consumer.• Note to Consumer – Keep theseinstructions for future reference.• Skill level – Installation of this appliancerequires basic mechanical skills.• Completion time – Refrigerator Installation20 minutesWater Line Installation30 minutes• Proper installation is the responsibility ofthe installer.• Product failure due to improper installationis not covered under the Warranty.PREPARATIONMOVING THE REFRIGERATOR INDOORSIf the refrigerator will not fit through a doorway,the refrigerator door and freezer drawer or door(depending on model) can be removed.• To remove the refrigerator door, see Step 1in the Reversing the Door Swing section.• To remove the freezer drawer, see theRemoving the Freezer Drawer section.• To remove the freezer door, see Steps 2and 3 in the Reversing the Door Swingsection.PREPARATION (cont.)WATER SUPPLY TO THE ICEMAKERIf the refrigerator has an icemaker, it will haveto be connected to a cold water line. A GE watersupply kit (containing tubing, shutoff valve,fittings and instructions) is available at extracost from your dealer, by visiting our Websiteat GEAppliances.com (in Canada atgeappliances.ca) or from Parts and Accessories,800.626.2002 (In Canada 1.888.261.3055).TOOLS YOU MAY NEEDAdjustable Wrench1/4″ Outer DiameterCompression Nutand Ferrule (sleeve)(icemaker models only) Phillips Head Screwdriver163/8″ Head Socket Driver(a 6-point socket isrecommended)