GE 20-27 Owner's Manual

Also see for 20: Owner's manual Use and care guide Use and care Owner's manual and installation instructions Owner's manual and installation instructions

14Customer Service Troubleshooting TipsOperating Instructions Safety InstructionsInstallation InstructionsCustomer Service Troubleshooting Tips Installation InstructionsSafety InstructionsOperating InstructionsCustomer Service Troubleshooting Tips Installation InstructionsSafety InstructionsOperating InstructionsPreparing to install the refrigerator.Read these instructions completely and carefully.Water Supply to the Icemaker (on some models)If the refrigerator has an icemaker, it will have to beconnected to a cold water line.A water supply kit (containing copper tubing,shutoff valve, fittings and instructions) is availableat extra cost from your dealer or from Parts andAccessories, 800-626-2002.Refrigerator LocationDo not install the refrigerator where thetemperature will go below 60°F (16°C)because it will not run often enough to maintainproper temperatures.Install it on a floor strong enough to support itfully loaded.ClearancesAllow the following clearances for ease ofinstallation, proper air circulation andplumbing and electrical connections:Sides 5/8″ (15 mm)Top 1″ (25 mm)If built-in, allow 7/8″(22 mm) for hinge covers.Back 1″ (25 mm)If the refrigerator is against a wall on either side,allow the following door clearances:20′, 22′, and 25′ models 3/4″ (19 mm)27′ models 11/2″ (38 mm)RollersThe rollers have 3 purposes:Rollers adjust so the door closes easily whenopened about halfway. [Raise the front about5/8″ (15 mm) from the floor.]To assure that the doors will close automaticallyfrom a halfway open position, there is a built-in tiltfrom the front to the back of the cabinet. Side-by-side refrigerators also have specially designed doorhinges that lift both doors slightly when opened,allowing the force of gravity to help close themsecurely.Rollers adjust so the refrigerator is firmlypositioned on the floor and does not wobble.Rollers allow you to move the refrigerator awayfrom the wall for cleaning.To adjust the rollers, remove the base grille by pullingit out at the bottom.Turn the roller adjusting screwsclockwise to raisethe refrigerator,counterclockwise to lower it. Use anadjustable wrench (3/8″ hex head bolt) or pliers.To replace base grille, align prongs on back of grillewith clamps in cabinet and push forward until grillesnaps into place.321