GE 21 Owner's Manual And Installation Instructions

Also see for 21: Owner's manual Use and care & installation guide Use and care & installation guide Owner's manual Use and care & installation guide

Contents

CONNECTING THE REFRIGERATOR TOTHE HOUSE WATER LINE (cont.)If you are using copper tubing, place acompression nut and ferrule (sleeve) onto theend of the tubing coming from the house coldwater supply.If you are using the GE SmartConnect ™tubing, the nuts are already assembled tothe tubing.If you are using copper tubing, insertthe end of the tubing into the refrigeratorconnection, at the back of the refrigerator, asfar as possible. While holding the tubing,tighten the fitting.If you are using GE SmartConnect ™ tubing,insert the molded end of the tubing into therefrigerator connection, at the back of therefrigerator, and tighten the compression nutuntil it is hand tight. Then tighten oneadditional turn with a wrench. Overtighteningmay cause leaks.Fasten the tubing into the clamp provided tohold it in position. You may need to pry openthe clamp.One of the illustrations below will look like theconnection on your refrigerator.Icemaker-Ready modelsIcemaker-Installed Models21Installation Instructions1ABC1/4″ TubingTubing Clamp1/4″CompressionNutFerrule(sleeve)SmartConnect™TubingRefrigeratorConnectionTURN ON THE WATER SUPPLY(icemaker and dispenser models)Turn the water on at the shut-off valve (house watersupply) and check for any leaks.2PLUG IN THE REFRIGERATOROn models with an icemaker, before plugging in therefrigerator, make sure the icemaker power switch is setto the O (off) position.See the grounding information attached to the powercord.3PUT THE REFRIGERATOR IN PLACEMove the refrigerator to its final location. Make sure theback side of the refrigerator engages the anti-tipbracket properly. The anti-tip floor bracket should lineup with the cutout in the back bottom of therefrigerator, and fit through the cutout when therefrigerator is pushed into position. (Refer to page 18,Step 2A for more information.)41/4″ CopperTubing1/4″ CompressionNutFerrule(sleeve)SmartConnect™TubingRefrigeratorConnectionTubingClampLEVEL THE REFRIGERATORTurn the front roller adjustingscrews clockwise to raise therefrigerator, counterclockwiseto lower it. Use a 3/8″ hexwrench with extension, or anadjustable wrench.To adjust the rollers on 21‘ Counter Depth models:These models also have rear adjustable rollersso you can align the refrigerator with your kitchencabinets. Use a 3/8″ hex wrench with extension to turnthe screws for the rear rollers—clockwise to raise therefrigerator, counterclockwise to lower it.5Roller adjusting screwsOfrecido por www.electromanuales.com