7Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions Installation InstructionsAbout the shelves and bins. www.GEAppliances.comRefrigerator Door Bins and Freezer Door Tilt-Out BinsLarge BinsThe larger refrigerator door bins andfreezer tilt-out door bins are adjustable.To remove: Lift the front of the bin straightup, then lift up and out.To replace or relocate: Engage the back sideof the bin in the molded supports of thedoor. Then push down on the front of thebin. Bin will lock in place.Small BinsTo remove: Lift the front of the bin straightup then out.To replace: Position the bin above therectangular molded supports on the door.Then slide the bin down onto the supportto lock it in place.The snugger helps prevent tipping, spillingor sliding of small items stored on the doorshelf. Place a finger on either side of thesnugger near the rear and move it backand forth to fit your needs.CAUTION: Onmodels with an icechute inside the topfreezer door bin, becareful when placingitems in the bin.Make sure thatitems do not blockor fall into the icechute.Not all features are on all models.Refrigerator binFreezer tilt-out binSnuggerFreezer binSlide-Out Spillproof ShelfThe slide-out spillproof shelf allows youto reach items stored behind others. Thespecial edges are designed to help preventspills from dripping to lower shelves.To remove:Slide the shelf out until it reaches the stop,then press down on the tab and slide theshelf straight out.Press tab and pull shelfforward to removeTo replace or relocate:Line the shelf up with the supports andslide it into place. The shelf can berepositioned when the door is at 90° ormore. To reposition the shelf, slide the shelfpast the stops and angle downward. Slideshelf down to the desired position, line upwith the supports and slide into place.Make sure you push the shelves all the way backin before you close the door.Do not block