Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips8Operation of electronic models (model GSD4000 Only)Lights What It Means What To DoThis is normal. Allow the dishwasher to drain and reset before you start a newThe START/RESET pad wash cycle.has been pressed.Control Error Press the START/RESET pad to turn off the beeper. If the CLEANlight continues to flash, call for service.Control Error Press the START/RESET pad to turn off the beeper and thedishwasher will attempt to reset. Restart the wash cycle.If this error continues, turn off the power to the dishwasher atthe circuit breaker for 30 seconds. Try the dishwasher again.If the error is still present, call for service.PLUS ABEEPINGSOUNDRESETSTARTSTARTCLEANCLEANPLUS ABEEPINGSOUNDUsing the Dishwasher DoorThe door must be closed and locked into place to select a LOAD SELECTION or an OPTION.If the door is opened during a cycle and left open, the dishwasher will beep once every 30 seconds until thedoor is closed and latched into place.21StartClose and latch the door. Touch the START/RESET pad to begin the cycle. Water fill begins andapproximately 60 seconds later the wash action begins.NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. Whenthe dishwasher is loaded and the door latch is in the locked position, the control panel lights will be ONand display the last settings you selected.If you don’t want to change any of the settings, simply touch the START/RESET pad to beginthe cycle.Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed.Make any new selections and touch the START/RESET pad to begin the cycle.CleanThis light is illuminated when a wash cycle is complete. The light will stay ON until the door is opened.Flashing Display Lights