![GE Advantium PSB9120 Installation Instructions Manual Manual pdf 16 page image](https://manuals-archive2.s3.amazonaws.com/5096644/b42305b959ce2b546fb1a378158400c016f.jpg)
16Installation Instructions6 INSTALL MOUNTING SCREWS Slide the oven the remaining way into the openingso that the side flanges and control panel areagainst the cabinet frame. Make sure that the ovenis centered in the opening. Open the door, place a turntable tray in the ovenand make sure that the tray in the unit is level. Drill pilot holes through the side flanges. Drive the color-matched screws into the sideflanges. It is recommended that the screwsbe hand tightened.If installing oven with an accessory storagedrawer: Open the drawer. Drill pilot holes through the side flanges. Drive color-matched screws into the side flanges.It is recommended that the screws be handtightened.NOTE: If installing the Profile Advantium 120V Ovenwith an accessory storage drawer, you must usethe Under-the-Counter (UTC) mounting bracket forthe drawer.If installing the Monogram Advantium integratedmodel ZSC1201 above 36s, the UTC mounting bracketfor the accessory storage drawer must be used.7 FINALIZE INSTALLATION Turn power on at the source. The interior lightshould come on when the door is opened. Refer to Owner’s Manual for operating instructions.4 INSTALL BOTTOM TRIMCAUTION: If installing the Advantium120V Oven below 36s, you must use the plasticbottom trim due to burn risk to children. The plastictrim acts as insulation and will help prevent burnsto children from hot surfaces.PRECAUCIÓN: Si va a instalar el hornoAdvantium de 120V debajo de 36”, usted debe utilizarel reborde inferior plástico debido al riesgo dequemaduras para los niños. El reborde plásticoactúa como aislante y evitará que los niños sufranquemaduras provocadas por las superficies calientes.NOTE: If installing the Advantium 120V Ovenwith an accessory storage drawer, the bottom trimis not required. Proceed to Step 5. Installation Below 36s, align trim tabs on the plastictrim to slots in the bottom of the oven. Installation Above 36s, align trim tabs on the plasticor metal trim to slots in the bottom of the oven. Secure the bottom trim to the bottom of the ovenusing 3 screws provided.5 INSTALL BOTTOM TRIM WITHACCESSORY DRAWERIf installing with an accessory drawer, seeinstallation instructions on page 17 or instructionsthat come with the accessory drawer.MetalTrimPlasticTrim ORPlasticTrim