GE Built-In Dishwashers Use & Care Manual

Also see for Built-In Dishwashers: Installation instructions Owner's manual

Contents

19DishwasherSettingsSetting a signalIf you want the machine to signal when the wash is complete, you can program it to do this.The machine is set without a signal by default.1. Switch off the dishwasher at the main switch.2. Hold in the DELAY start button at the same time as you press themain switch. The button flashes. Release the button.3. Press the CYCLE button – when the Auto wash symbol lights, thesignal is activated.4. Press the START/RESET button and the setting will be stored until next timeyou want to make a change.or Reset1. Switch off the dishwasher with the main switch.2. Hold in the DELAY start button at the same time as you press themain switch. The button flashes. Release the button.3.Press the CYCLE button – when the Auto wash symbol goes out, thesignal is deactivated.4. Press the START/RESET button and the setting will be stored until next timeyou want to make a change.