GE CDT 725-765 Series Owner's Manual

Also see for CDT 725 Series: Owner's manual Owner's manual Owner's manual Owner's manual Owner's manual

Contents

GE CDT 725-765 Series Owner's Manual Manual pdf 24 page image

Before you call for service…Troubleshooting TipsSave time and money! Review the charts on the following pages, or visit GEAppliances.com.In Canada visit www.GEAppliances.ca. You may not need to call for service.Problem Possible Causes What To DoStart status The door was opened or the • Press the Start button once and close the door to start the dishwasher.indicator light flashing cycle was interrupted. Press the Start button a second time when the dishwasher is running onlyif you wish to cancel the cycle.Dishwasher BEEPS This is a reminder that your • Press Start and close the door.once every minute dishwasher door has been leftopen during operation. It willcontinue beeping until you pressStart and close the door.Display shows Possible leak is detected • Some models are equipped with leak detection and the cycle will be cancelled if“LEAK DETECTED” a leak is detected. The display will show “LEAK DETECTED”. Call for service.Beeping at the end This is normal. The dishwasher • To turn off the double beep indicator (or re-activate it if it was previouslyof the cycle will beep twice at the end of the turned off), press the Heated Dry button 5 times within 3 seconds.(on some models) cycle. A triple beep will sound to indicate the end-of-cycle beep optionhas been turned on or off.Dishes and flatware Ultra Fine or Fine filter is clogged • See the Care and cleaning section.not clean Low inlet water temperature • Make sure inlet water temperature is correct (see the Using the dishwashersection). Turn on the hot water faucet nearest the dishwasher, let run untilthe water temperature stops rising. Then start the dishwasher and turnoff the faucet. This ensures the entering water is hot. Select Wash Temp Boostor Boost Temp if available.Water pressure is temporarily low • Turn on a faucet. Is water coming out more slowly than usual? If so, waituntil pressure is normal before using your dishwasher.Air gap or disposer is clogged • Clean the air gap or flush the disposer.Improper rack loading • Make sure large dishware does not block the detergent dispenser or thewash arms. See the Loading the dishwasher section.Poor performing detergent • Use a highly rated detergent such as Cascade ® Platinum Pacs.Leak detected • Some models are equipped with leak detection and the cycle will be cancelled ifa leak is detected. The display will show “LEAK DETECTED”. Call for service.Spots and filming Extremely hard water • Use rinse agents such as Cascade® Complete Rinse Aid to prevent spots andon glasses and prevent new film buildup.flatware • If water is extremely hard, a softener may be required.Low inlet water temperature • Make sure water temperature is at least 120°F (49°C).Overloading or improper • Load dishwasher as shown in the Loading Place Settings section.loading of the dishwasherOld or damp powder detergent • Make sure detergent is fresh.Rinse agent dispenser empty • Refill with rinse agent such as Cascade® Complete Rinse Aid.Too little or low performing • Make sure you use the proper amount of highly rated detergent.detergent24