INSTALL MOTORInstallation Instructions177Motor Attachment Bracket1 Ft = 0.3 m1” = 2.5 cmINSTALL DUCT COVERS9To install the 12” duct cover alone:• Place the 12” section of the decorative duct cover ontop of the hood.• Secure the cover to the top of the hood with 4 screwsprovided.To install the 12” duct cover alone:• Place the 2-piece duct cover on top of the hood.• Secure the bottom cover to the top of the hood with4 screws provided. See illustration, page 16.• Extend the inside section upwards to meet the ceilingand ceiling bracket.• Secure the duct cover to the bracket with the 2 smallPhillips screws provided.IMPORTANT: Hold the connector sothe two square corner terminalsare at the top as you positionthe connector to plug it in.Motor Hooks• Align and engage theslots in the blowerassembly to the 3 hooksat the rear of theexhaust opening.• Rotate motor upwardsuntil it aligns with theattachment screwlocation.• Secure the motor toattachment bracket atthe front of theopening with washerand screw provided.• Plug the motor connector intothe mating hood connector.See the illustration for thehood connector location.Touch the hood to locate andmake the connection.ABCDCONNECT ELECTRICAL8• Use wire nuts to connect incoming ground to green,white to white and black to black.• Push wires into junction box and replace cover. Besure wires are not pinched.RemoveJunction BoxCoverGroundInsert PowerCoduit ThruStrain Reliefand TightenWhiteCheck That White, Black andGreen Hood Wires Are ThreadedThru Small Hole in BracketBlackWARNING:If house wiring is not 2-wire with a ground wire, aground must be provided by the installer. When housewiring is aluminum, be sure to use cUL. approved anti-oxidant compound and aluminum-to-copperconnectors.Verify that power is turned off at the source.Use cUL Listed Wire NutsINSTALL FILTER SUPPORT10• Tip filter support into the rear of the hood.• Insert support tabs into the slots at the rear of thehood.• Secure the support to the hood with screws as shown.Insert Tabs into SlotsInsert 2 Screws