GE CV936 Owner's Manual & Installation Instructions

Also see for Appliances CV936: Owner's Manual & Installation Instructions Owner's manual and installation instructions Owner's Manual & Installation Instructions Owner's manual and installation instructions Owner's manual and installation instructions

Contents

Installation instructionsINSTALL MOTOR• Align and engage tileslots in tile blowerassembly to the 3 booksat the rear of theexhaust opening°MotorHook_• Rotate motor upwards r_-__1ooo oo i_until it aligns with. th.e ,A_r_"_LattacbmdK screwlocation.• Sectlre the illotoi toattachment bracketat the front of theopening with washerand screw provided. S__//ylx_the mating hood connector. See /!_i_ \ :connector location. Touch the _hood to locate and make tile //COllllectioll. (_IMPORTANT: Hold tile _x_ __L_f_connector so tlle two square_'_J_ _--]--O_.L_corner terminals are at tile top__ you \_-_ Jposition tile connector to plug it in.CONNECT ELECTRICALVerify that power is turned off at the source.AWARNING" [] Ifhouse wiring is not2-wire with a ground wire, a ground must be providedby the insmllm: When house wiring is aluminmn, besure to use U.L. approved and-oxidant colnpoundand aluminmn-to-copper connectors. / -o .............. .__A Remove C Insert Power ,_"_,Junction Box ConduitThru i'a_(" ._,_Cover Strain Relief '\ "%_"_t;_ I /,andTighten _ ,,___.A..__y_.... " .... . . _/IIDi I II i_ ...........WhiteGround--.._I I Z_.J /_glacl<B CheckThat White, Blackand ['_/ff _ [GreenHoodWires AreThreadedIt_/"!_,,,/'_g_ _ IThruSmall Holein Bracket _ JD UseULListedWire Nuts* Use wire nuts to connect incoming ground to green,white to white and black to black.e Push wires intojmlction box and replace cover.Be sure wires are not pinched. 17INSTALL DUCT COVERSTo install the 12 "duct cover alone:* Place tlle 12" section of tlle decorative duct cover ontop of tlle hood.e Secure tile cover to tile top of tile hood with 4 screwsprovided.To install the 2-piece duct cover:* Place tlle 2-piece duct cover on top of tile hood.* Secure tile bottom cover to the top of the hood with4 screws provided. See illustration, page 16.* Extend tlle inside section upwards to meet tlleceiling and ceiling bracket.* Secure the duct cover to the bracket with the 2 smallPhillips screws provided.INSTALL FILTER SUPPORT* Tip filter support into tile rear of tile hood.* Insert support robs into the slots at the rear oftile hood.//¢/InsertTabsIntoSlots/* Secure the support to the hood with screws as shown.