GE DBL333 Owner's Manual

Also see for DBL333: Owner's manual Owner's manual and installation instructions Owner's manual and installation instructions Owner's manual and installation instructions Technical service guide

Contents

GE DBL333 Owner's Manual Manual pdf 10 page image

Using the four shipping carton corner posts(two on each side), carefully lay the dryer on itsleft side and remove foam shipping pad.CAUTION: To prevent damage, do not use thecontrol panel as a means to pick up or movethe dryer.Return the dryer to an upright position.Adjust the leveling legs to match the washerheight. The dryer must be level and rest firmlyon all four leveling legs.32110Preparing to install your dryer.Read these instructions completely and carefully.Customer Service Troubleshooting TipsOperating Instructions Safety InstructionsInstallation InstructionsCustomer Service Troubleshooting Tips Installation InstructionsSafety InstructionsOperating InstructionsCustomer Service Troubleshooting Tips Installation InstructionsSafety InstructionsOperating InstructionsWARNINGn This dryer must be exhausted to the outdoorsusing only rigid metal or flexible metal 4″diameter ductwork for inside the dryer cabinetor exhausting.nNever use plastic or other combustible ductwork.See Exhausting section.n This appliance must be properly groundedand installed as described in theseInstallationInstructions.n Do not install or store appliance in an area whereit will be exposed to water/weather. SeeLocationof Your Dryer section.n The National Fuel Gas code restricts installationsofgas appliances in garages. They must be 18″(45.7 cm) off the ground and protected fromvehicles by a barrier. SeeLocation of Your Dryersection.n Theelectrical service to the dryer must conformwith local codes and ordinances and the latestedition of the National Electrical Code,ANSI/NFPA 70.n Thegas service to the dryer must conform withlocal codes and ordinances or the latest edition ofthe National Fuel Gas Code ANSI Z223.1.The gasdryer is designed under ANSI Z 21.5.1 forhomeuse only. This dryer is not recommended forcommercial applications such as restaurants orbeauty salons, etc.Unpacking the DryerFoam shipping padPackingn Phillips head screwdrivern Channel-lock adjustable pliersn Carpenter’s leveln Flat or straight blade screwdrivern Duct tapen Rigid or flexible metal 4″ (10.2cm) ductn Vent hoodn Pipe thread sealer (GAS DRYER )n Plastic knifen 1/2″ open-end wrenchTools and Materials Required for Dryer Installation