GE DCXH46 Owner's Manual & Installation Instructions

Also see for Spacemaker DCXH46: Owner's Manual & Installation Instructions Owner's manual Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's manual and installation instructions

GE DCXH46 Owner's Manual & Installation Instructions Manual pdf 20 page image

The numbers in the illustration correspond to steps.5. Using the blade end of a putty knife covered withmasking tape, carefully remove the hole plugs locatedin the bottom of the dryer front panel.6. Remove the 4 legs from the dryer base.7. Place the dryer on top of the washer. Slide the dryerback into the rear brackets (7A) then drop the frontdown over the front brackets (7B).Stacking Instructions–Reversing Door Swing20REVERSING THE DRYERDOOR SWING1. Open the dryer door. Remove the 4 hinge hole plugs orscrews from the left side of door opening. Place nearbyfor future installation. NOTE: You may need a plastic knifeto help pull out the plugs. Be careful not to scratch the paint.2. Remove the four screws that secure the door hinges tothe dryer front panel. NOTE: Remove 1 screw from eachof the 2 hinges first. Hold the door firmly before removing thelast 2 screws.3. Rotate the door 180° and reinstall the door hinges to thedryer front panel with the 4 screws.4. Install the 4 hinge hole plugs or screws that wereremoved in step 1 into the open screw holes on the rightside of the door opening.Remove 4 screws—one from each hinge first8. Insert the 2 long screws provided in the kit throughthe holes in the dryer front panel and install into thefront mounting brackets.9. Install the hole plugs removed in step 5.10. Refer to the washer and dryer installation instructionsfor proper installation and function.11. Save the top panel and brackets in the case of futureside-by-side use.