GE DDE7109S Use And Care Manual

Contents

GE DDE7109S Use And Care Manual Manual pdf 11 page image

These instructions are for changing the hinges from If you need to change the hinges from the left side tothe right side to the left side. the right side, follow these same instructions (merelyreverse all references to the left and right).Tools NeededStandard #2 Phillips screwdriverTape-tipped putty knifeNeedle-nosed pliersDryer Door1. Open the door and remove the filler plugs fromthe side of the opening without hinges. Use a tape-tipped putty knife to pry plugs loose and then gentlyremove plugs with a pair of needle-nosed pliers.2. With the doorcompletely open,remove the bottomscrew from each hingeon the dryer face.3. Insert these screwsabout half way intothe top holes, for K\ *W “ ~–)1II i ---‘L&-)each hinge, on theopposite side (wherefiller plugs were removed). Applyfirm pressure to get screw started inuntapped holes.4. Loosen the top screw fromeach hinge on the dryer facehalf way. mI@Qo5. With one hand holding the top –of the door and the other handholding the bottom, remove thedoor from the dryer by lifting it up and out.h+y~?>6. Rotate the door 180°. Insert it ~1/IIon the opposite side of the ~. . .opening by moving the doorin and down until the top /hinge and the bottom hinge sare resting on the top screws !\ Uliinserted in step 3.7. Remove the remainingscrews from the side ofthe opening from whichthe door was removed.With these screws, 1’ @ Q- -wsecure each hinge atthe bottom. ,0@@8. Tighten the two topscrews of each hinge.9. Reinsert the plastic plugs onthe side from which the door was removed.11