GE DPI 610 IS User Manual

Also see for DPI 610 IS: User manual User manual

10K249 Issue No. 4Task SelectionTask KeyThe TASK key is used to set up the instrument for a number of specific types oftest. There are two modes BASIC and ADVANCED and nine other specific types oftest which automatically configure the instrument on selection from the TASKmenu. The tasks available under the TASK menu are held on three pages shownbelow. To select a task from the menu, press the TASK key, position the cursor overthe desired task and press the ENTER key as shown below. Use the right/left cursorkeys to switch between pages.Using TASK FunctionsSpecific tasks are selected as shown above. The following diagrams show how toconnect the unit under test (UUT) for each task selectable under the TASK menu.Input and Output units, where applicable can be selected by pressing either theINPUT or OUTPUT keys as shown below.Set UnitsNote: If the four units displayed are not the units required, press SETUP, selectSETTINGS and refer to Page 36.