GE DSKP333ECWW - Spacemaker 120V 3.6 cu. Ft. Electric Dryer Dimensions And Installation Information

Also see for Spacemaker DSKP333EC: Owner's manual and installation instructions Dimensions and installation information

For answers to your Monogram,® GE Profile™ orGE® appliance questions, visit our website atge.com or call GE Answer Center® service,800.626.2000.360430Specification Revised 5/09Listed byUnderwritersLaboratoriesDSKP333ECGE Spacemaker ® Portable DryerDimensions and Installation Information (in inches)Dryer Note:Dryer wall outlet must be locted within 36" of service cord entry and accessiblewhen dryer is mounted in position.80100120140OFF102030OFFOFFEXTRADRYOPTIMUMREGULAR HEAT605040302010cool downcooldownAU TO M AT I C CYC L ENO HEATF L U F F CYC L EPUSH TO START HIGH HEAT* PREFERRED SETTINGT I M E D CYC L EDSKP333ECWW33-1/424-1/223-7/8Special Installation RequirementsAlcove or Closet Installation:• If your dryer is approved for installation in an alcove or closet, it will be stated ona label on the dryer back.• The dryer MUST be exhausted to the outside.• Minimum clearances between dryer cabinet and adjacent walls or othersurfaces are:0" either side3" front and rear• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”.• Closet doors must be louvered or otherwise ventilated and must contain aminimum of 60 sq. in. of open area equally distributed. If this closet containsboth a washer and a dryer, doors must contain a minimum of 120 sq. in. of openarea equally distributed.• No other fuel-burning appliance shall be installed in the same closet witha gas dryer.Bathroom or Bedroom Installation:• The dryer MUST be exhausted to the outdoors.• The installation must conform with the local codes, or in the absence of localcodes, with the National Electric Code and National Fuel Gas Code, ANSI Z223for gas dryers.Minimum Clearances other than Alcove or Closet Installation:• Minimum clearances to combustible surfaces0" both sides3" rear

/ 3

Related manuals for GE Spacemaker DSKP333EC