GE DSXH47 Owner's Manual & Installation Instructions

Also see for DSXH47EG: Dimensions and installation information Dimensions and installation information Dimensions and installation information Technical service guide Tech manual

Contents

GE DSXH47 Owner's Manual & Installation Instructions Manual pdf 9 page image

BEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT – Save theseinstructions for local inspector’s use.• IMPORTANT – Observe allgoverning codes and ordinances.• Note to Installer – Be sure to leave theseinstructions with the Consumer.• Note to Consumer – Keep these instructionsfor future reference.• Skill level – Installation of this appliance requiresbasic mechanical and electrical skills.• Completion time – 1–3 hours• Proper installation is the responsibility of theinstaller.• Product failure due to improper installation is notcovered under the Warranty.WARNING• This dryer must be exhausted to the outdoors. Useonly rigid metal or flexible metal 4" diameter ductworkfor exhausting to the outside. Use only rigid metal 4"diameter ductwork inside the dryer cabinet.• Never use plastic or other combustible ductwork. SeeExhausting section.• This appliance must be properly grounded andinstalled as described in these Installation Instructions.• Do not install or store appliance in an area where it willbe exposed to water/weather. See Location of Your Dryersection.• The National Fuel Gas code restricts installations ofgas appliances in garages. They must be 18″ (45.7 cm)off the ground and protected from vehicles by abarrier. See Location of Your Dryer section.• The electrical service to the dryer must conform withlocal codes and ordinances and the latest edition of theNational Electrical Code, ANSI/NFPA 70.• The gas service to the dryer must conform with localcodes and ordinances or the latest edition of theNational Fuel Gas Code ANSI Z223.1. The gas dryer isdesigned under ANSI Z 21.5.1 for home use only. Thisdryer is not recommended for commercial applicationssuch as restaurants or beauty salons.FOR YOUR SAFETY:9If you have any questions, call 800.GE.CARES (800.432.2737) or visit our Website at: ge.comIN THE COMMONWEALTH OFMASSACHUSETTS• This product must be installed by a licensedplumber or gas fitter.• When using ball-type gas shut-off valves, theyshall be the T-handle type.• A flexible gas connector, when used, must notexceed 3 feet.Installation Spacemaker DryerInstructions Model DSXH47