GE DVM1950 Technical Service Manual

Also see for Appliances DVM1950: Owner's manual Installation instructions Owner's manual Installation instructions Owner's manual

GE DVM1950 Technical Service Manual Manual pdf 22 page image

– 22 –Interior LightThe interior light is 120 VAC, 50 watt halogen bulb(Part # WB25X10026.)To remove the interior light:2. Using a Phillips-head screwdriver, remove thescrew securing the interior light cover.1. Remove the grille assembly. (See Grille Assembly.)3. Raise the bulb receptacle/bracket assembly.Note: Do not touch the surface of a quartz halogenbulb with bare fingers because the quartz surfacewill be exposed to the salts and oils on the skin. Thiswill cause heat to concentrate in this area and leadto premature lamp failure. If you happen to contactthe bulb with your fingers, carefully clean the quartzsurface with a gentle solvent, such as alcohol.To disassemble the door:1. Place the door, face down, on a protectivesurface.2. Using a putty knife, carefully pry the chokecover away from the door frame.3. Remove the Phillips-head screw from thebottom left corner that fastens the bottom ofthe oven door handle.4. Using a flat blade screwdriver, disengage the 9door frame retainers (3 each on top and bottom,2 on hinge pin side, and 1 on latch side), thenseparate the door frame from the door panel.5. Using long nose pliers, remove the latch spring,then slide and remove the latch from the choke.Latch SpringLatchRetainers (1 of 9)(Continued next page)Bulb Receptacle/Bracket Assembly