Installation InstructionsIT] ADJUST BROIL AND OVENBURNER AIR ADJUSTMENTSHUTTERS IF NECESSARYAir adjustment shutters for the top and bottom burnersregulate the flow of air to the flames.The air adjustment shutter for the top (broil) burner isin the center of the rear wall of the oven.ustmentshutterIThe shutter %r the bottom (oven) burner is near the backwall behind the warming drawe_; storage drawer or kickpanel. Remove the drawer or panel. See the Careandcleaningof therange section.To adjust the flow of air to either burner, loosen thePhillips head screw and rotate the shutter toward openor closed position as needed.The fl_unes for the top (broil) burner should be steadywith approximately 1" blue cones and should not extendout over the edges of the burner baffle.To determine if the bottom burner flames are burningproperly, remove the oven bottom. Flames should haveapproximamly 1" blue cones and, if range is suppliedwith natural gas, should burn with no yellow tipping.(With most LP gas, small yellow tips at the end of oumrcones are hernial.) Flames should not lift off"burnerports. If lifting is observed, gradually reduce air shutmropening until flames are stabilized.44IT1 ADJUST BROIL AND OVENBURNER AIR ADJUSTMENTSHUTTERS IF NECESSARY (CONT.)Oven bottomTo remove the oven bottom:A. Remove the screws holding down rear of the ovenbottom.B. Grasp the oven bottom at finger slots on each side.C. Lift the rear of the oven bottom enough to clear thelip of the range flvmle, push it back, and then pull itup and out.I-8-1LEVELING THE RANGEA. Install the oven sheh'es in the oven and position therange where it _11 be installed.Raise_1 _ range LowerLower range, _ _ rangeLeg _leveler--"'_Raise_"_range_(on some models) (on some models)B. Check for levelness by placing a spirit level or a cup,partially flled with wam_, on one of the oven shelves.If using a spirit level, rake two readings---with the levelplaced diagonally first in one direction and thenthe ethelC.D.t.Remove the storage drawer or kick panel. See die Careand cleaning of the range section. The fiont leveling legscan be adjusmd flom the bottom and the rear legs canbe adjusted flom the mp or the bottom.Use an open-end or adjustable wrench to adjust theleveling legs undl the range is level.At_er the range is level, slide the range away flom thewall so that the And-Tip device can be installed.