GE GDF510PSDSS Installation Instructions Manual

Also see for GDF510PGDBB: Use and care manual Owner's manual Dimensions and installation information Installation instructions Manual

Contents

GE GDF510PSDSS Installation Instructions Manual Manual pdf 5 page image

PREPARE HOT WATER LINE• The line may enter from either side, rear or floor within theshaded area shown in Figure F.• The line may pass through the same hole as the electricalcable and drain hose. Or, cut an additional 1-1/2" diameterhole to accommodate the water line. If power cord with plugis used, water line must not pass through power cord hole.Figure FWater Line Connection• Turn off the water supply.• Install a hand shut-off valve in an accessible location, suchas under the sink. (Optional, but strongly recommended andmay be required by local codes.)• Water connection is on the left side of the dishwasher. Installthe hot water inlet line, using no less than 3/8" copper tubing.Route the line as shown in Figure F and extend forward atleast 19" from rear wall.• Adjust water heater for 120°F to 140°F temperature.• Flush water line to clean out debris.• The hot water supply line pressure must be 20-120 PSI.Turn page to begin dishwasher installation.6"4"Cabinet FaceShut-offValve2" From Floor19" From Wall2"FromCabinet1-1/2" Dia.HoleHotInstallation Preparation5CAUTION:Do not remove wood base until you are ready to install thedishwasher. The dishwasher will tip over when the door isopened if base is removed.PRECAUCIÓN:No quite la base de madera hasta que esté listo para instalar ellavaplatos. Si se quita la base, el lavaplatos se volcará cuandose abra la puerta.