GE GDT645SYNFS Installation Instructions Manual

Also see for GDP645SYNFS: Installation instructions

READ CAREFULLYKEEP THESE INSTRUCTIONSCHECK THE FOLLOWING Tub trim does not interfere with the door Dishwasher is square and level at both the top and bottom of the cabinet opening,with no twisting or distortion of the tub or door All 4 legs of the dishwasher are firmly in contact with the floor Drain hose is not pinched between the dishwasher and adjacent cabinets or walls Tub trim is fully seated on the tub flangeWARNINGCAUTIONFOR YOUR SAFETYRead and observe all WARNINGS and CAUTIONSshown throughout these instructions.IMPORTANT – Observe all governing codes andordinances.• Note to Installer – Be sure to leave these instructionsfor the consumer’s and local inspector’s use.• Note to Consumer – Keep these instructions withyour Owner’s Manual for future reference.• Skill Level – Installation of this dishwasher requiresbasic mechanical, electrical and plumbing skills. Properinstallation is the responsibility of the installer.Product failure due to improper installation is notcovered under the GE Appliances Warranty. SeeWarranty information.• Completion Time – 1 to 3 Hours. New installationsrequire more time than replacement installations.IMPORTANT – The dishwasher MUST be installed toallow for future removal from the enclosure if service isrequired.Care should be exercised when the appliance isinstalled or removed, to reduce the likelihood ofdamage to the power supply cord.If you received a damaged dishwasher, you shouldimmediately contact your dealer or builder.Optional Accessories – See the Owner’s Manual foravailable custom panel kits.Your dishwasher is a water heating appliance.31-4000211 Rev 2 10-20 GEABEFORE YOU BEGINRead these instructions completely and carefully.• To reduce the risk of electric shock, fire, or injury topersons, the installer must ensure that the dishwasher iscompletely enclosed at the time of installation.• FOR PERSONAL SAFETY: Remove house fuse or opencircuit breaker before beginning installation. Do not usean extension cord or adapter plug with this appliance.• The improper connection of the equipment groundingconductor can result in a risk of electric shock. Checkwith a qualified electrician or service representative ifyou are in doubt that the appliance is properly grounded.• If house wiring is not 2-wire with ground, a groundmust be provided by the installer. When house wiringis aluminum, be sure to use UL-Listed anti-oxidantcompound and aluminum-to-copper connectors.• To reduce the risk of electric shock, fire, or injury topersons, the installer should check to ensure that wiresare not pinched or damaged, the house wiring is attachedto the junction box bracket through a strain relief, andall electrical connections made at the time of install (wirenuts) are contained inside of the junction box cover.Do not remove wood base until you are ready to installthe dishwasher. The dishwasher will tip over when thedoor is opened if base is removed.While performing installations described in this booklet,gloves, safety glasses or goggles should be worn.See your Owner’s Manual for details on how to contact us regarding installation questionsBuilt-In DishwashersInstallationInstructions