GE GFD45ESSK0WW Installation Instructions Manual

GE GFD45ESSK0WW Installation Instructions Manual Manual pdf 1 page image

BEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT – Save these instructions for localelectrical inspector’s use.• IMPORTANT – Observe all governing codes andordinances.• Install the clothes dryer according to the manufacturer’sinstructions and local codes.• Note to Installer – Be sure to leave these instructionswith the Consumer.• Note to Consumer – Keep these instructions for futurereference.• Clothes dryer installation must be performed by aqualified installer.• This dryer must be exhausted to the outdoors.• Before the old dryer is removed from service ordiscarded, remove the dryer door.• Service information and the wiring diagram are locatedin the control console.• Do not allow children on or in the appliance. Closesupervision of children is necessary when the applianceis used near children.• Proper installation is the responsibility of the installer.• Product failure due to improper installation is notcovered under the Warranty.• Install the dryer where the temperature is above 50°Ffor satisfactory operation of the dryer control system.• Remove and discard existing plastic or metal foil ductand replace with UL-listed duct.Questions? Call GE Appliances at 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.com- Fire HazardWARNING• Clothes dryer installation must be performed by aqualified installer.• Install the clothes dryer according to theseinstructions and local codes.• DO NOT install a clothes dryer with flexible plasticventing materials. If flexible metal (semi-rigid orfoil-type) duct is installed, it must be UL-listed andinstalled in accordance with the instructions foundin “Connecting the Dryer to House Vent” later inthis manual. Flexible venting materials are knownto collapse, be easily crushed and trap lint. Theseconditions will obstruct dryer airflow and increasethe risk of fire.• DO NOT install or store this appliance in anylocation where it could be exposed to water orweather.• To reduce the risk of severe injury or death, followall installation instructions.• Save these instructions. (Installers: Be sure to leavethese instructions with the customer.)Installation DryersInstructions 0431-16769-3 08-16 GEA234D2274P004Printed in MexicoIN THE COMMONWEALTH OFMASSACHUSETTS, THE FOLLOWINGINSTALLATION INSTRUCTIONS APPLY:• Installation must be performed by a qualifiedor licensed contractor, plumber, or gasfitterqualified or licensed by the State.• If using a ball valve, it shall be a T-handle type.• A flexible gas connector, when used, must notexceed 3 feet.FOR GAS DRYERS ONLY