- Fire HazardWARNING• Clothes dryer installation must be performed by aqualified installer.• Install the clothes dryer according to these instructionsand local codes.• DO NOT install a clothes dryer with flexible plastic ventingmaterials. If flexible metal (semi-rigid or foil-type) duct isinstalled, it must be UL-listed and installed in accordancewith the instructions found in “Connecting the Dryerto House Vent” later in this manual. Flexible ventingmaterials are known to collapse, be easily crushed andtrap lint. These conditions will obstruct dryer airflow andincrease the risk of fire.• DO NOT install or store this appliance in any locationwhere it could be exposed to water or weather.• To reduce the risk of severe injury or death, follow allinstallation instructions.• Save these instructions. (Installers: Be sure to leavethese instructions with the customer.)In the Commonwealth of Massachusetts,the following installation instructions apply:• Installation must be performed by a qualified orlicensed contractor, plumber, or gasfitter qualifiedor licensed by the State.• If using a ball valve, it shall be a T-handle type.• A flexible gas connector, when used, must notexceed 4 feet.FOR GAS DRYERS ONLYDryers04InstallationInstructionsBEFORE YOU BEGINRead these instructions completely and carefully.IMPORTANT – Save these instructions for local electricalinspector’s use.IMPORTANT – Observe all governing codes andordinances.• Install the clothes dryer according to the manufacturer’sinstructions and local codes.• Note to Installer – Be sure to leave these instructionswith the Consumer.• Note to Consumer – Keep these instructions for futurereference.• Clothes dryer installation must be performed by a qualifiedinstaller.• This dryer must be exhausted to the outdoors.• Before the old dryer is removed from service or discarded,remove the dryer door.• Do not allow children on or in the appliance. Closesupervision of children is necessary when the applianceis used near children.• Proper installation is the responsibility of the installer.• Product failure due to improper installation is notcovered under the Warranty.• Install the dryer where the temperature is above 50°F forsatisfactory operation of the dryer control system.• Remove and discard existing plastic or metal foil ductand replace with UL-listed duct.• Service information and the wiring diagram are locatedin the control console.31-16769-5 08-18 GEA234D2274P004See your Owner’s Manual for details on how to contact us regarding installation questions