GE GFDN100 Owner's Manual

Also see for DBVH520: Owner's manual Owner's manual Owner's manual Owner's manual Owner's manual

GE GFDN100 Owner's Manual Manual pdf 9 page image

9Operating Instructions Safety InstructionsConsumer Support Troubleshooting TipsAbout the dryer control panel.Dry TempYou can change the temperature of your dry cycle.ANTI-BACTERIAL This option may only be used with COTTONS or MIXED LOAD cycles. This option reduces(on some models) certain types of bacteria by 99.9%, including: Staphylococcus aureus, Pseudomonasaeruginosa and Klebsiella pneumoniae*. The anti-bacterial process occurs when highheat is used during a portion of this drying cycle.NOTE: Do not use this cycle on delicate fabrics.* The Anti-Bacterial Cycle is Certified by NSF International (formerly National SanitationFoundation) to NSF Protocol P154 Sanitization Performance of Residential Clothes Dryers.HIGH For regular to heavy cottons.MEDIUM For synthetics, blends and items labeled permanent press.LOW For delicates, synthetics and items labeled Tumble Dry Low.EXTRA LOW For lingerie and special-care fabrics.NO HEAT Can only be used with TIMED DRY.(on some models)STARTPress to start a dry cycle. If the dryer is running, press it once and it will pause the dryer.Press it again to restart the dry cycle.My Cycle (on some models)Set up your favorite combination of settings and save them here for one touch recall.These custom settings can be set while a cycle is in progress.To store a My CyClE combination of settings:1. Select your drying cycle.2. Change DRy TEMP and SENSOR DRy lEVEl settings to fit your needs.3. Select any drying OPTIONS you want.4. Press and hold the pad for three seconds to store your selection. A beep will soundand the pad will light up.To recall your stored My CyClE combination:Press the My CyClE button before drying a load.To change your stored My CyClE combination:Follow steps 1–4 in “To store a My CyClE combination of settings”.“ClEAN lINT FIlTER” (message)(This message represents only a reminder.)After the POWER button is pressed, the “ClEAN lINT FIlTER” message could appear if the previouscycle was not finished.This message will disappear after the START button is pressed. Even though you have already cleanedthe filter (before or after the POWER button has been pressed), the “ClEAN lINT FIlTER” message willstill be displayed until the START button is activated.MY C YCLE567