GE GSD6000 Series Installation Instructions Manual

Contents

GE GSD6000 Series Installation Instructions Manual Manual pdf 10 page image

Installation InstructionsSTEP 17–CONNECT DRAIN LINEFOLLOW ALL LOCAL CODES AND ORDINANCES.The molded end of the drain hose will fit 5/8" through 1"diameter inlet ports on the air gap, waste tee or disposer.• Determine size of inlet port• Cut drain hose connector on the marked line, if required, to fitthe inlet port.DRAIN LINE INSTALLATION• Connect drain line to air gap, waste tee or disposer using thepreviously determined method.Method 1 – Air gap with waste tee or disposerFigure ZFigure AA10• If a longer drain hose is required and you did not purchasedrain hose GPF10L, add up to 42" length for a total of 120"(10 feet) to the factory installed hose. Use 5/8" or 7/8" insidediameter hose and a coupler to connect the two hose ends.Secure the connection with hose clamps.Figure XFigure Y• Secure the drain hose to the air gap, waste tee or disposerwith clamps.Note: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEETFOR PROPER DRAIN OPERATION.Method 2 – Built-in “High drain loop” with waste tee ordisposerTip: Avoid unnecessary service call charges. Prior toconnecting drain hose be sure excess hose is not trapped,kinked or crushed by the dishwasher. Pull excess hose throughthe cabinet opening to prevent hose damage and pump outissues.923-10ACutting Line1" 5/8"IMPORTANT: Do not cut corrugated portion of hose�� Waste Tee Installation Disposer InstallationWaste Tee Installation Disposer InstallationFasten to undersideof countertop32"Min.18"Min.06C-1683C18"Min.32"Min.06C-1683DFasten to undersideof countertopIMPORTANT – When connecting drain line todisposer, check to be sure that the drainplug has been removed. DISHWASHER WILLNOT DRAIN IF PLUG IS LEFTIN PLACE.RemoveDrainPlug923-10N

/ 12

Related manuals for GE PDW7300J