GE GSS20 Series Technical Service Manual

Also see for GSS20 Series: Technical service guide

GE GSS20 Series Technical Service Manual Manual pdf 10 page image

– 10 –Clad Door PanelThe clad door panel is not on all models. Modelswith the clad door require special cleaning andhandling procedures.Removal and ReplacementNote: The screws that secure the clad panel tothe door require a Torx-30 screwdriver.Remove the hinge cover, 2 screws, and the upperhinge plate.Note: Upper and lower door hinge shafts are1/2 inch longer. The toe plate grille and top hingecovers have been modified to adapt to thesechanges.Lift the door off of the lower hinge.Disconnect the electrical connector shown below.Squeeze the tab and remove the light assembly.Fresh Food CompartmentLight and SwitchThe fresh food light socket will read 120 VAC withthe door open.Removal and ReplacementRemove 2 screws securing the control panel tothe refrigerator ceiling.TabDisconnect the electrical connector from the freshfood compartment light switch. Squeeze the taband push the light switch through the controlpanel.TabConnector