GE GSS20DBTWW - 19.9 cu. Ft. Refrigerator Owner's Manual

Also see for 20: Owner's manual Use and care guide Use and care Owner's manual and installation instructions Owner's manual and installation instructions

BEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT – Save theseinstructions for local inspector’s use.• IMPORTANT – Observe allgoverning codes and ordinances.• Note to Installer – Be sure to leave theseinstructions with the Consumer.• Note to Consumer – Keep these instructionsfor future reference.• Skill level – Installation of this appliance requiresbasic mechanical skills.• Completion time – Refrigerator Installation15 minutes• Proper installation is the responsibility of theinstaller.• Product failure due to improper installation is notcovered under the Warranty.• Do not install the refrigerator where the temperaturewill go below 60°F (16°C) because it will not run oftenenough to maintain proper temperatures.• Install it on a floor strong enough to support it fullyloaded.REFRIGERATOR LOCATIONQuestions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.comQuestions? In Canada, call 1.800.361.3400 or Visit our Website at: www.geappliances.caInstallation RefrigeratorInstructions Models 20, 22, 25Allow the following clearances for ease of installation,proper air circulation and plumbing and electricalconnections.• Sides 1/8″ (4 mm)• Top 1″ (25 mm)• Back 1″ (25 mm)A door clearance of 3/4″ (19 mm) is needed for a 90ºdoor opening which provides better access to the foodstorage area.CLEARANCESThe rollers have 3 purposes: Rollers adjust so the door closes easily when openedabout halfway. Rollers adjust so the refrigerator is firmly positionedon the floor and does not wobble. Rollers allow you to move the refrigerator away fromthe wall for cleaning.To adjust the rollers, remove the base grille by pulling itout at the bottom.Turn the roller adjusting screws clockwise to raise therefrigerator, counterclockwise to lower it. Use anadjustable wrench (3/8″ hex head bolt) or pliers.To replace base grille, line up the clips on back of grillebetween the bar and the bottom of the cabinet. Pushforward until grille snaps into place.ROLLERSIf the refrigerator has an icemaker, it will have tobe connected to a cold water line. A GE water supplykit (containing tubing, shutoff valve, fittings andinstructions) is available at extra cost from your dealer,by visiting our Website at ge.com (in Canada, atwww.geappliances.ca) or from Parts and Accessories,800.626.2002.WATER SUPPLY TO THE ICEMAKER(on some models)14