GE GTD65EBSJ Dimensions And Installation Information

Listed byUnderwritersLaboratoriesFor answers to your Monogram, GE Café™ Series, GE Profile™ Series orGE Appliances product questions, visit our website at geappliances.comor call GE Answer Center® Service, 800.626.2000. Specification Revised 8/17GTD65EBSJ/EBPLGE® 7.4 Cu. Ft. Capacity Aluminized Alloy Drum Electric Dryer With HE Sensor Dry22 1/2" 30 1/2"27"3 1/2"1 3/4"3 1/4"8"38 1/2"46"27"5"Power Cord 4 1/2"11 3/4"Side View Rear View5.7 cu. ft. Dryers2Back ViewPowerCord Hole30-1/25.8, 6.0 and 7.0 cu. ft. Dryers5Back ViewPowerCord Hole4-1/2POWER CORD LOCATIONSSIDE VIEWBACK VIEWREAR VIEWELECTRIC DRYER RATING:240V 5600W 24A 60Hz208V 4400W 22A 60HzEXHAUST OPTION: 4-way rear, right, left and bottomCIRCUIT REQUIREMENTS: An individual, properly-grounded branch circuit,protected by a 30-amp circuit breaker or a time-delay fuse, is required.NOTE: Dryer wall outlet must be located within 36" of service cord entry andacessible when dryer is mounted in position.INSTALLATION INFORMATION: For complete information, see installationinstructions packed with your dryer.DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)Special Installation RequirementsALCOVE OR CLOSET INSTALLATION:- If your dryer is approved for installation in an alcove or closet, it will be statedon a label on the dryer back.- The dryer MUST be exhausted to the outside.- Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:0" either side; 1" front, top and rear- Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in.of open area equally distributed. If this closet contains both a washer and a dryer, doors mustcontain a minimum of 120 sq. in. of open area equally distributed.- No other fuel-burning appliance shall be installed in the same closet with a gas dryer.BATHROOM OR BEDROOM INSTALLATION:- The dryer MUST be exhausted to the outdoors.- The installation must conform with the local codes, or in the absence of local codes, withthe National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.MINIMUM CLEARANCES OTHER THAN ALCOVE OR CLOSET INSTALLATION:- Minimum clearances to combustible surfaces are: 0" both sides; 1" rearDRYER EXHAUSTING INFORMATION : Use metal duct only, vertical and horizontal ducting.

/ 3

Related manuals for GE GTD65EBPL