GE GTDL740GDWW Use And Care Manual

Also see for GTDL740EDWW: Installation instructions Technical service guide Manual Dimensions and installation information Owner's manual

Contents

6SettingsIndividual settings for Timed Dry cycle minutes (Time), dryness level (Level), and temperature (Temp) can be set fromthe minimum (lowest in column) to maximum (highest in column). In general, the higher up the column, the moreenergy will be used.Time -Selection only for Timed cycles.Each “setting” allows you to specify a lower (1 tap) or an upper (2 taps) time working your way from aminimum 10 minute to a maximum 99 minute dry time (10, 20, 30, 40, . . . 80, 90, 99, 10 . . .)Dryness Level-Selection only used for Sensor cycles. Timed cycles run for the selected time.More Dry Use for heavy-duty or mixed type fabrics.Dry Use for a normal dryness level suitable for most loads. This is the preferred cycle for energy savings.Less Dry Use for lighter fabrics.Damp For leaving items partially damp.TemperatureHigh For regular to heavy cottons.Medium For synthetics, blends, delicates and items labeled permanent press.Low For delicates, synthetics and items labeled tumble dry low.Extra Low For delicates, synthetics and items labeled tumble dry low.Operating instructionsEOptionsDelay DryAs the Delay Dry button is repeatedly pressed, the delay time sets to from 1 to 9 hours, and back to clear (0). After selectingthe delay time, press Start and the delay time will count down the time remaining until the cycle starts.If the Delay Dry button is pressed for 3 seconds, it clears (regardless of the delay time) or terminates a delaying cycle.Extended TumbleUse this option to minimize the wrinkles in clothes. It provides 1 hour of no-heat tumbling after the clothes are dry. If you areusing the cycle Signal and you select the Extended Tumble option, a signal will sound at the end of the drying time and every5 minutes during the Extended Tumble cycle. This will remind you that it is time to remove the clothes.eDryAvailable for %XON\,WHPV7RZHOV6KHHWV1RUPDO0L[HG/RDGV&RWWRQV-HDQV'HOLFDWHVand&DVXDOV3HUPDQHQW3UHVV.When the eDry button is pressed, cycle settings change to reduce the total energy consumption of the selected sensor cycle.NOTE: Cycle times will change when eDry is selected.The eMonitor lights display the relative energy use of your selected cycle and options. They are provided as an energy guideand range from Good (1 light) to Better (5 lights). Cycle (time), dryness level, temperature, and additional tumble options canincrease or decrease your energy efficiency. Some special cycles will not provide a display.More OptionsDrum LightThe drum light will go on if the Drum Light button is pushed or the door is opened. It will stay on until the door is shut or theDrum Light or Power button is pushed.SignalUse the Signal button to change the volume of the end of cycle and control signals. Press the button until you reach thedesired volume (low-med-high) or off. The clothes should be removed when the beeper goes off so wrinkles do not set in.NOTE: Remove garments promptly at the sound of signal. Place clothes on hangers so wrinkles will not set in. Use the Signal especially when drying fabrics like polyester, knits and permanent press. These fabrics should be removed sowrinkles will not set in.Control LockYou can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started acycle. Children cannot accidentally start the dryer by touching buttons with this option selected.7RORFNWKHGU\HUFRQWUROV press and hold the Drum Light and Signal buttons at the same time for 3 seconds. The control lockicon will light up when locked.7RXQORFNWKHGU\HUFRQWUROV press and hold the Drum Light and Signal buttons at the same time for 3 seconds.NOTE: The Power button can still be used when the machine is locked.FG