GE GTDS855GDMC Use And Care Manual

Also see for GTDS850EDWS: Installation instructions Technical service guide Manual Dimensions and installation information

Contents

GE GTDS855GDMC Use And Care Manual Manual pdf 7 page image

7HFMy SettingsAs the cycle selector knob is turned, the Time (Timed Dry), Level (Dryness Level), and Temp (Temperature) settings change toautomatic pre-set default settings. If you desire a different setting, press the appropriate button(s). Then press and hold theMy Settings button for 3 seconds. The status heart and button lights will turn on and the dryer will save these settings for that knobselection. In the future, when you turn the selector knob to that cycle, your settings will be automatically recalled.To temporarily (for this load) return to the pre-set default settings, depress the My Settings button for 1/2 second. The status heartand button lights will turn off and the options will change back to these defaults. To make these default settings permanent, hold theMy Settings button again for 3 seconds to make them your preferred settings (the lights will turn back on).NOTE: Variable Signal volume cannot be set for My Settings.Variable SignalUse the Variable Signal button to change the volume of the end of cycle and control signals. Press the button until you reachthe desired volume (low-med-high) or off. The clothes should be removed when the beeper goes off so wrinkles do not set in.NOTE: Remove garments promptly at the sound of signal. Place clothes on hangers so wrinkles will not set in. Use the Variable Signal especially when drying fabrics like polyester, knits and permanent press. These fabrics should beremoved so wrinkles will not set in.Drum LightThe drum light will go on if the Drum Light button is pushed or the door is opened. It will stay on until the door is shut or theDrum Light or Power button is pushed.Control LockYou can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started acycle. Children cannot accidentally start the dryer by touching buttons with this option selected.7RORFNWKHGU\HUFRQWUROV press and hold the Control Lock button for 3 seconds. The control lock icon will light up when locked.7RXQORFNWKHGU\HUFRQWUROV press and hold the Control Lock button for 3 seconds.NOTE: The Power button can still be used when the machine is locked.eDryAvailable for %XON\,WHPV7RZHOV6KHHWV&RWWRQV1RUPDO0L[HG/RDGV-HDQV&DVXDOV3HUPDQHQW3UHVV$FWLYH:HDU,and Delicates. When the eDry button is pressed, cycle settings change to reduce the total energy consumption of theselected sensor cycle. NOTE: Cycle times will change when eDry is selected.The eMonitor lights display the relative energy use of your selected cycle and options. They are provided as an energy guideand range from Good (1 light) to Better (5 lights). Cycle (time), dryness level, temperature, and additional tumble options canincrease or decrease your energy efficiency. Some special cycles will not provide a display.GEAppliances.comGOptionsDelay DryAs the Delay Dry button is repeatedly pressed, the delay time sets to from 1 to 9 hours, and back to clear (0). After selectingthe delay time, press Start and the delay time will count down the time remaining until the cycle starts.If the Delay Dry button is pressed for 3 seconds, it clears (regardless of the delay time) or terminates a delaying cycle.Extended TumbleUse this option to minimize the wrinkles in clothes. It provides 1 hour of no-heat tumbling after the clothes are dry. If you areusing the cycle Signal and you select the Extended Tumble option, a signal will sound at the end of the drying time and every5 minutes during the Extended Tumble cycle. This will remind you that it is time to remove the clothes.Damp AlertThis option causes the dryer to beep when clothes have dried to a damp level. Remove items that you wish to hang dry. TheDamp Alert will only beep when this option is selected (but the dry cycle will keep running). Removing clothes and hanging themwhen they are damp, can reduce the need to iron some items. The light beside the button will be lit when Damp Alert is on.Rack DryRack Dry is only allowed for timed cycles (Timed Dry & Quick Fluff). The light turns off if cycle knob is turned to a non-timed cycle.TemperatureHigh For regular to heavy cottons.NOTE: Steam Dewrinkle and Steam Refresh require the High temperature setting.Medium For synthetics, blends, delicates and items labeled permanent press.Low For delicates, synthetics and items labeled tumble dry low.Extra Low For delicates, synthetics and items labeled tumble dry low.No Heat For fluffing items without heat. For use only with the Timed Dry cycles.E