6.1.2 Insert the pin on the center hinge into the socket in thetop of the door. Place the spacer, then the washer, onthe hinge pin.NOTE: The center hinge mustbe turned over as shown whenmounted on the left side.Installation Instructions5.4.3 Remove the screw from theright top edge of the doorand insert it into the handlescrew hole on the left side.5.4.4 Transfer the door stop as shown in precedingsection 5.2.5.4.5 Attach the handle to theright edge of the door withscrews at top and bottom,using bottom holes vacatedby removal of the door stopscrews.TOPBOTTOMTopBottom5.4 Transfer Freezer Door Handle5.4.1 Remove the screwholding the handleto the top of thedoor and the twoscrews holding thehandle to the bottomof the door.5.4.2 Remove the handle.14Plastic Washerand SpacerHinge Pin6.2 Re-hang the freezer door6.2.1 Lower the freezer dooronto the centerhinge pin. Be surethe washer andspacer are in placeon the pin.RE-HANGING THE DOORS (CONT.)6Center HingePinPlastic Washerand SpacerREVERSING THE DOOR SWING (CONT.)26.1.3 Tilt the door toward the cabinet. As the door is broughtinto position, slide the hinge under the head of the screwwhich earlier had been partly driven into the outermosthole. Insert the remaining screw, then tighten bothscrews securely.6.1 Re-hang the fresh food door6.1.1 Lower the fresh food door onto thebottom hinge pin. Be sure the washeris in place on the pin.RE-HANGING THE DOORS6PlasticWasherHingeBracket6.2.2 Tilt the door toward the cabinet, lifting the top hinge soWKHSLQ¿WVLQWRWKHVRFNHWRQWKHWRSRIWKHGRRU6.2.3. Make sure the door is slightly above the top of thecabinet and the gap between the doors is evenacross the front. Tighten the top hinge screws. Do notovertighten these screws–tighten them until they arejust snug, then turn them another one-half turn.REVERSING THE DOOR HANDLES (CONT.)5