GE HTDP120ED0WW Owner's Manual

Also see for HTDP120ED0WW: Owner's manual

Contents

About the control panelTowels/Sheets For most towels and linens.Speed DryEnergy SaverSteam Refresh(on some models)Steam Dewrinkle(on some models)For small loads that are needed in a hurry, such as sport or school uniforms. Canalso be used if the previouscycle left some itemsdamp, such as collars or waistbands.NOTE:On some models,the time remaining inthe cyclewill show counting down in the display.For cottons and most linens.The cycle offersa reduction in energy use when compared to the Cottonscycle.Thedryer automatically sets the most energy efficient settings and only changes to the Dryness Levelare allowed by the user.For slightly wrinkled dry garments. Significantly reduces wrinkles. After the Steam Refresh cycle,the unit will beep (if Signal is selected)and display "00."Steam Refresh is recommended for 1-2 garmentsNOTE: Steam cycles are not intended for use with towels.NOTE:A single extremely light fabric item may need to have an additional item included inthe Steam Refresh cycle to achieve optimum results.Important - the temperature setting must be set to HIGH and water must be turned onbefore running the Steam Refresh cycle.For use with larger loads than Steam Refresh. Ideal for loads left in the dryer for an extended time.Steam Dewrinkle is recommended for 8-13 garmentsNOTE: Steam cycles are not intended for use with towels.Important - the temperature setting must be set to HIGH and water must be turned onbefore running the Steam Refresh cycle.OptionsDewrinkle TumbleUse this option to minimize the wrinkles in clothes. It provides 30 minutes of no-heat tumbling after the clothes are dry. If youare using the cycle Signal and you select the Dewrinkle Tumble option, a signal will sound at the end of the drying time andseveral times during the Dewrinkle Tumble cycle. This will remind you that it is time to remove the clothes.Extended TumbleUse this option to minimize the wrinkles in clothes. It provides i hour of no-heat tumbling after the clothes are dry. If youare using the cycle Signal and you select the Extended Tumble option, a signal will sound at the end of the drying time andseveral times during the Emended Tumble cycle. This will remind you that it is time to remove the clothes.Damp AlertThis option causes the dryer to beep when clothes have dried to a damp level. Remove items that you wish to hang dry. TheDamp Alert will only beep when this option is selected (but the dry cycle will keep running). Removing clothes and hangingthem when they are damp, can reduce the need to iron some items. The light beside the pad will be lit when Damp Alert ison.Delay DryOn models with a Time Remaining display, as the Delay Dry pad is repeatedly pressed,the delay time sets to 30 minutes, 1_hour, 2 hours, 4 hours, 8 hours, and back to clear (0 minutes).After selecting the delay time, press Start and the delay time willcount down the time remaining until the cycle starts.On models without a Time Remaining displag, as the Delay Dry pad is repeatedly pressed, the delay time sets to 2 hours, 4hours, 8 hours, and back to clear (0 hours).For all models, if the Delay Dry pad is pressed for 3 seconds, it clears (regardless of the delay time).SignalUse the Signal pad to change the volume of the end of cycle signal. Pressthe pad until you reach the desired volume or off.The clothes should be removed when the beeper goes off so wrinkles do not set in.NOTE:• Remove garments promptly at the sound of signal. Placeclothes on hangers so wrinkles will not set in.• Use the Signal especially when drying fabrics like polyester, knits and permanent press.These fabrics should be removed sowrinkles will not set in.6