GE HTS16BBRL Owner's Manual And Installation Instructions

Also see for 16: Owner's manual and installation instructions User guide Owner's Manual & Installation Instructions Owner's manual and installation instructions Owner's manual and installation instructions

Installation InstructionsREVERSING THE DOOR SWING (CONT.)2REVERSING THE HARDWARE44.1 Remove the base grille (if your refrigerator hasone) by pulling it straight out.4.3 Interchange hinge (and the shim glued to it) andscrews at top right with screws at top left of cabinet.Do not tighten screws on hinge side at this time.NOTES:• Some hinges have four holes. Which holes youuse for installing the hinge depends on whichside you install the hinge.• The outer edge of the hinge should be parallelto the edge of the case for correct installation.Installing the hinge on the left. Installing the hinge on the right.REVERSING THE DOOR HANDLES55.1 Transfer fresh food door handle5.1.1 Remove the handle plug using atape-tipped putty knife under the edge,and remove the screw underneath.Remove the two screws holding thehandle to the top of the door.5.1.2 Remove the handle.5.1.3 Remove the screws from the right edge of thedoor top and insert them into the handle screwholes on the opposite side.TopScrewsfor HandleHoles5.1.4 With tape-tipped putty knife or thin-bladescrewdriver, pry out the plug button from thehinge hole on the left side of the door andinsert it into the hole on the opposite side thatwas vacated by removal of the top hinge.Plug ButtonPlug204.2 Move the bottom hinge bracket (and shim gluedto it) and plastic washer from the right side to theleft side.PlasticWasherHingeBracketModels with a hinge bracketthat has 2 screw holes. Models with a hinge bracketthat has 4 screw holes.Switch the hinge pin to theopposite side of the bracket.PlasticWasherHingeBracket