GE HVM1540SNSS Installation Instructions Manual

Also see for HVM1540SNSS: Owner's manual

GE HVM1540SNSS Installation Instructions Manual Manual pdf 17 page image

Place the blower unit back into the opening.Roll the blower unit 90° so that fan bladeopenings are facing out the back of theoven.4BEFORE: Fan BladeOpenings Facing UpAFTER: FanBlade OpeningsFacing Back21 Remove the two screws that hold the blower plateand remove the screw holding the blower motorto the oven. Slide blower plate from under itsretaining flange.ADAPTING BLOWER FOROUTSIDE BACK EXHAUSTB5.17Carefully pull out the blower unit. The wireswill extend far enough to allow you to adjustthe blower unit.Blower PlateBlower PlateReplace the blower plate in the same positionas before and replace the screws for theblower plate and blower motor.Before Rolling After RollingBack of OvenBack ofOvenBack ofOvenCAUTION: Do not pull or stretch the blowerunit wiring. Make sure the wires are not pinched.NOTE: The blower unit exhaust openings shouldmatch exhaust openings on rear of oven.Installation InstructionsRetainingFlangeBlower Plate ScrewsBack ofOven3 Rotate blower unit counterclockwise 180°.Before Rotation After RotationBack ofOven Back ofOven56Blower Motor Screw