Catalog Number: RSEN-W121DESCRIPTION AND OPERATIONLine-voltage Wall Switch Occupancy SensorTotal Lighting ControlInstallation InstructionsIMRSEN-W12FEATURESThe RSEN-W12 is a self-contained motion-sensinglighting control which replaces a conventional wallswitch for energy savings and convenience. Lights turnoff automatically after a room is vacated.Built-in sensors produce low intensity, inaudible sound anddetect changes in sound waves caused by motion, such aswalking into the room, reaching for a telephone, turning in achair. The sensor does not respond to audible sound.In the Automatic ON mode, the lights turn on automaticallywhen a person enters the room. In the Manual ON mode,lights are turned on by pressing the touchplate on the switch.Modes can be changed by flipping the concealed switch underthe touchplate. In either mode, lights will remain on as longas motion is detected in the room. When no motion is detected,the lights will turn off automatically after the pre-set timedelay. Following this, a “grace period” of approximately tenseconds allows lights to be turned on again by motion.At any time, lights may be turned off while the room isoccupied by pressing the touchplate. The RSEN-W12 is fullyself-resetting; lights turned off manually in Automatic ONmode will stay off while the room remains occupied. After theroom is vacated and the preset time delay and grace periodhave elapsed, the lights will remain off until turned onautomatically the next time someone enters the room.The RSEN-W12 can be used with a standard toggle switch tosplit the lighting load for rooms that are wired for twoswitches as shown in the wiring diagram.• Replaces a conventional wall switch• For use in small rooms or offices up to 300 square feet• One model for either 120 VAC or 277 VAC• Choice of automatic ON or manual ON modes• Separate time delay and sensitivity adjustments• For indoor use onlyBefore proceeding, read the enclosed installationinstructions. For GE TLC Service, call: 1-877-584-2685(USA) or 1-800-661-619 (Canada).